Two screws
A morning job, not a trade job
The bracket takes two fixings and the flex reaches an ordinary socket. Nothing is cut into a wall and nothing is certified, because nothing is wired into the building.
Plug-In Wall Sconces
Hangs on two screws. Plugs into the socket you have.
The light people want on a wall and never install, because installing it means a cable in the plaster. This one does not.
Not on sale yet Expected around RM297.00, complete
Up the wall
Where a perforated shade is at its best
Against a wall the pattern is thrown as well as lit - the shade casts what it is pierced with. Bone throws a soft field; slate throws an edge.
Switched
On the flex, at hand height
An in-line switch on the cable, so it works like a lamp rather than needing the wall plate a hard-wired light would.
LED only
The right bulb, in the box
6 W, 2700 K. The same limit as the rest of the range: PLA softens near 60 C.
Wall light without an electrician.
Printed to order in Malaysia, one at a time, in a wall a single bead thick.
What is in the box.
Everything needed to have it working the day it arrives. No wiring, and no separate trip for a bulb.
- Shade
- Small — 150 mm across, 140 mm tall, printed in a 0.42 mm wall.
- Plug-in wall bracket
- E27 holder, 2 m braided flex, in-line switch, plug fitted Hangs on two screws and reaches an ordinary socket.
- E27 LED bulb, 2700 K
- 6 W, warm white, non-dimmable The bulb these are designed around. See the bulb guide.
- Colours
- Four. Bone passes about 60% of the light, slate about 23% — pick by what you want the light to do, not by the colour off.
- Made
- To order. Ships by Fri 2 Oct.
Not yet
The shade is ready; the plug-in wall bracket is not in stock yet. Ask to be told when it is. Get in touch →
If you are not sure
Which size should I choose?
The measurement is the widest part of the shade, which is how lampshades are sold and how they are shelved.
Small suits a bedside table or a shelf. Table is the one most people want and fits a standard table lamp. Pendant is wider and shallower because it is seen from below and further away.
If the shade is going on a lamp you already own, measure the widest point of the old shade rather than its height.
What does the colour change?
More than the look. The wall is 0.42 mm thick, so the colour decides how much light gets through it as well as what colour that light is.
Bone passes about 60% of the light and gives the softest, most even glow. Slate passes about 23%: switched off it reads as a solid dark object, and switched on almost all you see is the pattern itself. Clay sits between them and throws amber.
Choose bone or sand if the lamp is meant to light the room. Choose clay or slate if it is meant to be the thing you look at.
How does it attach to my lamp?
Every shade has an E27 ring built into it, printed as one piece with four spokes. E27 is the ordinary large screw fitting used almost everywhere outside North America.
It drops over the lampholder and is held by the shade ring, the same as a fabric shade. Nothing is glued and nothing needs assembling.
If you have no lamp yet, add the cord set to hang it, or the wood base to stand it on a table.
Which bulb, and why it matters
LED only, 6 W or less, and this one is not a preference.
The shade is printed in PLA, which softens at around 60 C. An incandescent or halogen bulb inside a shade this close will distort it. An LED runs cool enough that it never gets near.
2700 K is the warm white these are rendered and finished against. A cooler bulb will make bone look grey.